Calibrating for Latency

Calibrating your DAW for latency is an increidibly important first step not to be forgotten. Depending on your audio interface and computer setup the latency i.e. delay between what you play and what is recorded can be significant. Furthermore, if you are not aware of the issue it can really be disconcerting since it will seem like you have timing issues.

On Windows reduced latency is achieved by using ASIO drivers. Once you have an ASIO driver installed the next step is to determine what the lowest buffer setting is where your interface still operates normally. Abnormal operation is discernible due to audible pops, clicks and glitches. The lower your buffer setting the lower your latency but having low latency is still not enough with regards to recording. The goal is to actually “zero off” latency i.e. calibrate your DAW so that an a sample size offset is specified so that there is no latency at all.

So how do you do that? Well, you conduct an experiment which is known as a loop back test. I learned about how to set this up from a thread I started at the Reaper forum.

These are the steps:

  1. Find a sample audio material such as a click track or very simple drum loop.
  2. Set the master output of your daw to a specific out on your audio interface . say Out # 1.
  3. Arm a track for recording and set its input to a specific input on your audio interface , say In#1
  4. Physically connect with a patch cable the on your audio interface Out #1 to In #1.
  5. Record a few seconds of the material.
  6. Use an audio editor to find the crest of a discernible piece of audio on your original drum loop. Make sure that timeline on your DAW is set to show samples and note what sample the crest resides. See figure above.
  7. Do the same for the recorded material.
  8. Determine the difference in samples between the original material and the recorded material. This is your offset.
  9. Add the offset to your DAW’s preference settings for latency offset.
  10. Repeat the experiment making sure that the offset has been applied and saved to your preferences.
  11. Confirm that the second time around that the original material and the recorded material line up perfectly.

If using Reaper there’s a project file availble in the thread I have a link for above. The thread has some interesting discussions on latency and is a good read. Check it out.

2 thoughts on “Calibrating for Latency

  1. whaz

    Hi Charles,
    I’ve enjoyed (albeit with attendant frustration as I try to learn about reaper, recording, etc.) your input and follow through . . . I am wondering about the audio editor. Is that something on reaper or something to download separately?
    I too put (esp. Matheny) in the pantheon of Music Gods, tho I tend to favor his earlier work. McLaughlin can be pretty er self-indulgent, but there’s alot of beautiful music in there. His Return to Forever stuff is often amazing and listenable. Do you listen to Pandora? It’s a free internet “radio station” that is a great way to find new artists . . . anyway, prolly old hat.
    Nice work on your site, look foreward to hearing some music.

  2. Charles A. Monteiro

    The audio editor I was using was the one provided by Adobe Audition. In Reaper you can isolate a track by selecting it and using the keyboard combo:

    shift ~

    you would need to change the time display to show samples and work with the grid settings. Its doable , just find Adobe Audition more comfortable. You can try Audacity. Check it out here:

    http://audacity.sourceforge.net/

    I do like McLaughlin’s Bello Horizonte album. Must admit that I had not realized that he had been involved with Return To Forever. I do agree that Pandora is a great site to bump into great music. I discovered Oregon and Steve Tibbits among many there recently.

    thanks for your comments, its nice to know some people actually read the blog. Someday, I’ll get more active. Going thru a lot on the composition front.

Comments are closed.